Universal Joint (UJ)
|
Universal Joint with internal circlips. Same UJ for all the rear shaft on models where a single UJ is used. UJ also fits the single joint on the front prop shaft at the Differential end, but does NOT fit any of the wide angle double joints most commonly found on the front prop at the transfer box end but can also be found on the MK5 and KZN185 on the rear prop. |
TR002 |
£12.75 ex VAT
£15.30 inc VAT
|
|
Info
|
|
Rear Propshaft Centre Bearing Carrier
|
Rear Propshaft Centre Bearing carrier, comes complete ready to bolt on with bearing, rubber mount and cage. 1984 - 7/1997
|
TR006 |
£49.95 ex VAT
£59.94 inc VAT
|
|
Info
|
|
Front prop shaft (IFS)
|
New aftermarket complete Front prop shaft as per original design with cardan (wide angle joint) setup.
Fits;
Models with Independent front suspension (IFS)
Mk4 (LN165), Mk5 (KDN165) and LN107.
Always grease shaft prior to fitment.
(Transfer box to front diff)
OUT OF STOCK
Enter your mobile number below for an instant update when back in stock
|
TR003 |
£195.00 ex VAT
£234.00 inc VAT
|
|
Info
|
|
Gearbox Mount
|
Rear Gearbox Mount, fits to the bottom of the Transfer box to the cross member. 1979 - Onwards
|
TR001 |
£29.00 ex VAT
£34.80 inc VAT
|
|
Info
|
|
Diff Carrier Bearing
|
Diff Carrier Bearing 1985 on. 2 required for complete overhaul.
Require's diff to be removed in order to replace the carrier bearings.
Please Note;
we sell the NSK manufactured bearing as use by OEM due to the extreme loadings on carriers. |
RA008 |
£28.00 ex VAT
£33.60 inc VAT
|
|
Info
|
|
Diff Inner Pinion Bearing
|
Diff Inner Pinion Bearing 1985 on. The largest and inner most bearing supporting the pinion shaft and can only be replaced removing the diff and stripping.
|
RA006 |
£26.00 ex VAT
£31.20 inc VAT
|
|
Info
|
|
Diff Outer Pinion Bearing
|
Diff Outer Pinion Bearing 1985 on
. This is the most common bearing to fail in the diff and is the most outer bearing, fits just behind the diff pinion seal where the prop bolts on. |
RA007 |
£13.00 ex VAT
£15.60 inc VAT
|
|
Info
|
|
Differential Pinion Nut
|
Front and Rear Differential pinion nut. Fits where the prop bolts on to the pinion flange. |
TR011 |
£3.25 ex VAT
£3.90 inc VAT
|
|
Info
|
|
Differential Pinion Spacer
|
Differential Pinion Spacer (crush washer) 1984 - Onwards
|
TR010 |
£15.00 ex VAT
£18.00 inc VAT
|
|
Info
|
|
Gasket Differential
|
Main Differential to axle casing gasket.
|
FA010 |
£2.00 ex VAT
£2.40 inc VAT
|
|
Info
|
|
Differential Pinion Flange Seal
|
Front and Rear Differential pinion flange seal. Fits behind where the prop bolts on to the pinion
flange.
|
FA004 |
£5.00 ex VAT
£6.00 inc VAT
|
|
Info
|
|
Prop shaft centre bearing nut
|
Rear prop shaft centre bearing nut. Holds the centre bearing to the front section of the rear shaft.
Genuine part. |
TR008 |
£2.25 ex VAT
£2.70 inc VAT
|
|
Info
|
|
Front Gearbox housing output shaft seal 5 Speed
|
Front Gearbox housing output shaft seal, 5 Speed only, fits in housing that the thrust bearing run's on inside the bell housing. |
TR012 |
£7.00 ex VAT
£8.40 inc VAT
|
|
Info
|
|
CV grease tub
|
A tub of CV grease for the CV joint on the Hilux pickup. Use one tub per hub when replacing the seals or CV joint. 500G
Do not use on front wheel bearings.
|
Si034 |
£4.75 ex VAT
£5.70 inc VAT
|
|
Info
|
|
Transfer box output flange seal
|
Transfer box output shaft seal that fits behind the flanges on the transfer box, often found leaking. The same seal is fitted where both the rear prop bolts onto the flange and the where the front prop bolts onto the flange.
|
TR015 |
£9.00 ex VAT
£10.80 inc VAT
|
|
Info
|
|
Manual Free Wheeling Hub
|
Ultra reinforced nodular iron body. Salt-spray tested epoxi enamel finish. Die cast aluminium cap. Corrosion resistant glossy finish. Internal components: Precision machined, heat treated. Comes complete with hub gasket. A direct replacement of the original Toyota manual free-wheeling hub. For Independent Suspension models only, 26 spline unit, also fit the Surf models that had the locked hub flange with the dome cap on the end.
Sold Individually!
|
FA049 |
£40.00 ex VAT
£48.00 inc VAT
|
|
Info
|
|
Outer CV Boot (Gaiter)
|
Very strong Outer CV Boot (Gaiter) with grease and clips, specifically for this model and not a universal "cut to fit" boot. This Outer CV boot is the one closest to the wheel.
Fitting tip!
Outer CV boots on these models are fitted by removing the inner joint and sliding the boot on from the inner end, not by drifting off the outer CV joint as quite often the case on cars.
|
FA017 |
£7.95 ex VAT
£9.54 inc VAT
|
|
Info
|
|
Front of Rear Prop Shaft
|
NEW Complete Front of rear prop shaft.
(Gearbox to centre bearing)
|
TR021 |
£140.00 ex VAT
£168.00 inc VAT
|
|
Info
|
|
Rear of Rear Prop Shaft
|
NEW Complete rear of rear prop shaft.
(Centre Bearing to Diff)
|
TR020 |
£140.00 ex VAT
£168.00 inc VAT
|
|
Info
|
|
Rear of Rear Prop Yoke (flange)
|
Genuine Toyota Prop shaft yoke (flange).
Fits to;
1. Rear diff flange with 4 bolts
2. Front of the rear shaft where it bolts to the transfer box with 4 bolts
3. On the pickups the flange where it bolts to the centre bearing carrier
4. Front of front prop where it bolts to the diff flange.
Use prop UJ TR002 if required. This is the most common area of the prop to wear if continually used with a worn UJ.
|
TR022 |
£52.00 ex VAT
£62.40 inc VAT
|
|
Info
|
|
Multipurpose Lithium Grease
|
General multipurpose top quality lithium based grease. Outstanding high temperature stability. Suitable for most general purpose and automotive applications. Ideal for front wheel bearings, UJ's etc. 500G. |
WC010 |
£4.50 ex VAT
£5.40 inc VAT
|
|
Info
|
|
Needle Nose Grease Dispenser
|
Needle Nose Grease Dispenser, for use with all leading brands of manual grease guns NOT power greasers. Dispenses a fine bead of grease. Long nozzle gives access to hard to reach areas. Ideal for CV joints or lubricating Universal Joints (UJ's) where a normal gun won't fit on. |
WC025 |
£11.95 ex VAT
£14.34 inc VAT
|
|
Info
|
|
Inner & Outer CV Boot Kit
|
Special Offer!
New & Improved Inner & Outer CV gaiter boot kit. Complete with CV grease and clips for both Inner & Outer.
RoughTrax CV boots are specifically made to fit and are NOT universal.
The Inner CV boot is nearest the differential and the Outer CV boot is nearest to the wheel.
TOP TIP!
Outer CV boots are fitted by removing the inner joint and sliding the boot on from the inner end, not by drifting off the outer CV joint as quite often the case on cars.
WAS £16.75!
Fits Models: Hilux Pickup Mk4, Mk5 & LN107, Hilux Surf LN130, KZN130 & UK 4Runner.
|
CVBK |
£12.00 ex VAT
£14.40 inc VAT
|
|
Info
|
|
Silicone RTV Gasket Maker
|
Black Silicone RTV Gasket Maker
Vital Black RTV is the original gasket maker formulated for heavy duty applications. It makes reliable "ormed-in-place" gaskets that resist cracking, shrinking and migration caused by thermal cycling.
Ideal to replace almost any cut gasket. Also use to coats pre-cut gaskets to increase reliability.
It is permanently flexible and stable at temperature of between -80°c to +600°c (-62°c to +315°c ) intermittent.
It is also highly resistant to auto and shop fluids.
Applications: Valve covers, oil pans, timing covers, water pumps, thermostat housing, transmission pans etc.Packaging Size: 3 oz. (85gm) tube carded, 2.47 oz. (70gm) tube carded
|
WC028 |
£3.99 ex VAT
£4.79 inc VAT
|
|
Info
|
|
Complete Front Drive Shaft
|
Genuine Toyota Complete front drive shaft for independent front suspension (IFS) models. Complete with Genuine Inner & Outer CV Boots, clips and grease.
Fits Models: Hilux Surfs LN130, KZN130 , 4Runner & Hilux Pickups LN107, LN165, KDN165.
Stocked to order, please allow 3-4 days delivery! |
FA064 |
£256.00 ex VAT
£307.20 inc VAT
|
|
Info
|
|
80W-90 Gear Oil
|
1 Litre Genuine Toyota 80W-90 Gear Oil for Manual Transmission Gearboxes and Front & Rear differentials. Top quality oil as used by the Toyota dealerships.
API: GL-5
NOT FOR LIMITED SLIP DIFFS. |
TR030 |
£6.99 ex VAT
£8.39 inc VAT
|
|
Info
|
|
