Part Number: RAMS004
A new Genuine Toyota Rear Crown Wheel and Pinion kit 41201-09810, supplied with all the bearings, seal and gasket sealant for the Hilux Pickup KUN26 between 10/2006 - 08//2011 with 5-speed Manual transmission and Standard rear differential (Not LSD or Locker) - please check note below.
Quite simply this kit contains the best quality components you can buy.
Worldwide, Toyota designed several rear differential setups with the same ratio 43:12, this kit has the crown wheel/pinion of OE # 41201-09810,
If in doubt then we will be happy to confirm correct fitment for you. Please either:
- Email: firstname.lastname@example.org or Textus on +44 (0) 7786 206 960 with your full chassis number and we will confirm this is correct for your actual vehicle
Polite Product awareness:
This kit has been put together containing all Genuine Toyota components except the bearings which are from Koyo who are in fact the OEM suppliers of these bearings anyway.
With the work that is involved in a differential rebuild, it simply isn't cost effective fitting cheap parts so we only supply the best quality available in this area.
Once purchased, the kit cannot be split up and individual parts returned for credit as per our T&C's, it is sold as a kit at a kit price so please be aware before making your purchase.
The kit is perfect if you know that you have a tooth missing from either crown wheel or pinion, if not then we do also list just a bearing and seal repair kit without the crown wheel and pinion. We would always advise you check the differential before making your decision.
The fitting of such components should only be carried out by a reputable technician, one that fully understands the effects of incorrect bearing pre-loads or crown wheel and Pinion backlash tolerances for example. Gearbox specialists are usually a good option for rebuilding differentials if you are having issues in finding a qualified fitter.
This complete kit contains the following components:
- Genuine Toyota Crown wheel & Pinion kit - 41201-09810 Ration 43:12 (43 teeth on the crown wheel with 12 on the pinion)
Crown Wheel & Pinion matched set with new bolts to mount crown wheel to carrier housing
Pinion bearing spacer also called the collapsible spacer tube
Pinion shaft differential Seal
- OEM Koyo Inner Pinion Bearing
- OEM Koyo Outer Pinion Bearing
- OEM Koyo Left Hand Carrier Bearing
- OEM Koyo Right Hand Carrier Bearing
- Gasket sealant by Eristic
If the differential bearings have any movement of play this can put an increased stress onto the Crown Wheel Gear and can easily snap or damage the teeth beyond repair. This will then require replacement of the Crown Wheel and matching Pinion.
Brand / Manufacturer: Toyota
MPN (Manufacturer Part Number): 41201-09810
OE Equivalent Part Number: 41201-09810, 90080-36214, 90080-36216, 90080-36215(2)
Date Codes: 10/2006-08/2011
Fitting Position: Rear Differential
Unit of Sale: Rear differential crown wheel, pinion, nut, seal, spacer, x4 bearings, sealant
Q. Is this a job for a general "DIY" enthusiast?
A. In short, No, these components are virtually all Genuine Toyota parts, they require exacting tolerances during rebuild not only for bearing pre-loads but also correct Crown Wheel and Pinion back lash/alignment, failure to assemble to Toyota's specification will almost certainly result in an early failure of either bearing's or at worst gear teeth.
Q. Who is best qualified to make the repair?
A. If your usual technician feels this is too big a job, and it can be! then try contacting a local gearbox specialist, they are usually more than capable with the understands of differential rebuilds.
Most will welcome the fact they are using Genuine Toyota or OEM parts as guaranteed quality and fit.